after the 10 log channels are fully stored with
frequencies, the oldest memory is deleted and
the new frequency is stored in that channel.
You can scan the log channels along with the
normal 1000 channels.
• The 10 log channels are located after Channel
999. You can access them by selecting S-00 to
S-09 or by manually entering channel numbers
1000 to 1009.
• You cannot program frequencies in the log
channels.
• You can lock out the log channels like normal
channels.
• The scanner stores signals found by the Signal
Stalker I even if the logging function is off. The
frequencies in the log channels are deleted
when the scanner is turned off.
4: Alert Beep
Set this function to 1: On if you want the
scanner to beep when Signal Stalker I finds a
frequency.
5: Alert Light
Set this function to 1: On if you want the
scanner to light when Signal Stalker I finds a
frequency.
6: Band Switch
Lets you select the Signal Stalker I band.
0 25-54 VHF Low Band
1 108-137 AIR Band
2 137-225 VHF High Band
3 400-512 UHF Band
4 806-956 800MHz Band
(without Cellular
Band)
To Next Page
Loading...
