Radio Shack RPO-137 - Using the Backlight Display; Using the Auto Backlight Display; Using Power-On Light

15
Using the Backlight Display
To turn on the display light for easy viewing at
night, press / . The display lights for 15
seconds. If you press / again during the display,
the scanner continue to light 15 seconds more.
Using the Auto Backlight Display
You can set the scanner so the auto backlight
turns on for about 5 seconds when the scanner
receives signals. If you press a key within 5
seconds, the display remains lighted for more
than 5 seconds.
To turn auto backlight display on or off:
1. Press Menu.
2. Rotate the knob to select 6: Settings, then press
E
PGM
.
3. Rotate the knob to select 1: Back Light, then
press E
PGM
.
4. Rotate the knob to select 1: Auto Light, then
press E
PGM
.
5. Rotate the knob to select 1: On or 2: Off, then
press E
PGM
. Press and hold Menu to exit the
Menu mode.
Using Power-On Light
You can set the scanner so the auto backlight
turns on for about 5 seconds when the scanner is
turned on.
1. Press Menu.
2. Rotate the knob to select 6: Settings, then press
E
PGM
.
3. Rotate the knob to select 1: Back Light, then
press E
PGM
.
4. Rotate the knob to select 2: Power On Light, then
press E
PGM
.