Using Signal Stalker I
To turn on Signal Stalker I, press Func + 0 /
Signal Stalker On appears. Every two seconds, the
scanner searches for frequencies in the range you
specified. When the scanner finds a frequency,
it alerts you according to its settings and Found!
Press any key appears. Press any key to confirm the
displayed frequency. Rotate the knob to resume
scanning.
To turn off Signal Stalker I and turn on normal
scanning, press Func + 0 / .
If the Signal Stalker I Only Mode option is set to
on, pressing Func + 0 /
opens Signal Stalker I
in Only Mode. The icon flashes.
Note: In Signal Stalker I Only Mode, the
scanner only tries to find Signal Stalker I
transmissions. The scanner displays the band
meter for input signals in each band. If the
scanner loses a transmission, it resumes signal
stalker search.
Band Meter for Signal Stalker I
This meter allows you to see which band Signal
Stalker I is searching for. When a strong and
consistent signal is detected, this meter will rise
up to Max.
However, even if this meter rises to Max, the
scanner might not be able to catch the signal
if it is out of range or locked-out. To improve
performance if this happens, disable the band
by pressing the band number on the keypad.
Alternatively, disable the band within the Band
Switch in the Signal Stalker I options.
To Next Page
Loading...
