RD4000 Locating System User Manual
Page 53
T10 TRANSMITTER TRIP SWITCH
Note: This feature and procedure apply only to some models. Other models do not have this feature fitted.
If the transmitter is being used to generate a signal on a mains power cable, and the power supply is
accidentally switched on, the transmitter will sense that power has been applied and will operate the trip circuit
to protect the transmitter from damage. If this happens ‘TRIPPED’ will be displayed on the screen and all
transmitter functions will be disabled.
To reset the transmitter proceed as follows:
1. Switch off the transmitter.
2. Remove the power source from the cable.
3. Disconnect the transmitter from the cable.
4. Remove the battery housing.
5. Using a pen, press the reset switch, ensuring that it clicks when pressed. The reset switch is located in the
transmitter housing (see illustration)
6. Replace the battery housing.
7. Switch the transmitter on.
8. Ensure that the transmitter does not display ‘TRIPPED’.
If the power source is not removed from the cable, it will not be possible to reset the transmitter.
To Next Page
Loading...
Need help?
General
