AP70 Instructions for Use - English
Date: 2020/03 Page 13/14
5. Technical Specifications
Standards:
Safety IEC60065:2002, UL60065:2007, CAN/CSA C22.2 No.60065:03, CLASS I
EMC CISPR11, EN/IEC61000-4-2
Mains nominal input voltage:
100 - 240V~
Mains frequency:
50 - 60Hz
Consumption (Nominal):
200 Watt
Fuse:
1 x 6,3AT Located on the main PCB
Output Overload Protection:
Short circuit protected.
Output Power, one channel alone:
110WRMS continues for 10 minutes at 8Ω.
140WRMS continues for 10 minutes at 4Ω.
Output Power, both channels active:
2x70WRMS continues for 10 minutes at 8Ω.
2x70 WRMS continues for 10 minutes at 4Ω. (2x100W in 4Ω <10s)
Input:
Balanced and isolated
Input impedance: 2kΩ
Max sensitivity: 0.3VRMS for max output, with adjustable with pre-set potentiometers.
Max input voltage: 7VRMS
Frequency Range:
20-20.000 Hz ± 3dB with 8Ω load.
Noise:
>98dB signal/noise ratio, A-weighted measured.
Channel Separation:
Typical > 60dB undistorted output on opposite channel.
Total Harmonic Distortion:
< 0.2 % @ 70W..
Dimensions (W x D x H):
40 x 21.5 x 8.2 cm / 15.8 x 8.5 x 3.2 inches
Weight:
3.9kg / 8.6lb
Environment:
Operation Temperature: 15 - 35°C
Operation Humidity: 30 - 90% RH, Non-condensing
Transportation and storage of this unit should be within the following environmental conditions:
Transportation: -20° to 50°C
Storage: 0° to 50°C
Humidity: 10 - 95% RH, Non-condensing. Keep dry.
To Next Page
Loading...