RADWAG AS PLUS Series User Manual

- 92 -
OMI <CR><LF>
n_”Nazwa modu” <CR><LF>:
n_”Nazwa modu” <CR><LF>
OK <CR><LF>
–
command carried out, response: accessible working modes
OMI_I <CR><LF>
– command understood but not accessible at this moment
Mode name – parameter, working mode name, inserted in between inverted comas. The name takes
form given on a particular balance display, it is provided in a currently selected language.
n – parameter, decimal value determining working mode number.
n →
1 – Weighing
2
– Parts Counting
3
– Percent Weighing
4
– Dosing
5
– Formulas
6
– Animal Weighing
8
– Density of Solid Bodies
9
– Density of Liquids
10
– Peak Hold
11
– Totalizing
12
– Checkweighing
13 – Statistics
CAUTION! Working modes numbering is identical for each kind of balance. The numbers are assigned to
working modes names. Some balances give only the number as a response.
An example 1:
Command:
OMI <CR><LF>
– return accessible working modes
Response:
OMI <CR><LF>
2_”
Parts counting” <CR><LF>
4_”
Dosing” <CR><LF>
12_”Checkweighing” <CR><LF>
–
accessible working modes are given in
return:
mode number + name
OK <CR><LF>
– command carried out
An example 2:
Command:
OMI <CR><LF>
– return accessible working modes
Response:
OMI <CR><LF>
2 <CR><LF
>
4 <CR><LF>
12 <CR><LF>
–
accessible working modes are given in
return:
mode number
OK <CR><LF>
– command carried out
Set working mode
Command overview: Command sets particular working mode.
Format: OMS_n <CR><LF>
Response options:
OMS_OK <CR><LF>
– command carried out
OMS_E <CR><LF>
– error in-course of command execution, no parameter or incorrect
format
OMS_I <CR><LF>
– command understood but not accessible at this moment
n – parameter, decimal value determining working mode number. To see detailed description go to
OMI command
An example:
Command:
OMS_13<CR><LF>
– set Statistics mode
Response:
OMS_OK<CR><LF>
– Statistics mode set
Give current working mode
Command overview: Command returns currently set working mode.
Format: OMG <CR><LF>
Response options:
OMG_n_OK <CR><LF>
– command carried out, response: current working mode
OMG_I <CR><LF>
– command understood but not accessible at this moment
n – parameter, decimal value determining working mode number. To see detailed description go to
OMI command.

RADWAG AS PLUS Series Specifications

General

Display	LCD with backlight
Power Supply	100-240 V AC 50/60 Hz
Calibration	Internal / External
Interface	RS232, USB-A, USB-B
Operating Temperature	+10° - +40°C
Pan Size	ø 85 mm
Repeatability	0.1 mg
Linearity	±0.2 mg
Stabilization time	2-3 seconds