- 18 -
4. START-UP
• Plug the power adapter to a socket, next connect the connector to port located at the back of
the housing.
• Press button located in the top right hand corner of the terminal.
• Wait until start-up procedure is completed, the home screen of balance software is displayed
automatically.
• The balance runs with no user logged in. In order to start operation it is necessary to carry out
the logging procedure (for detailed logging procedure read later sections of this user manual).
CAUTION!
Remember to start the balance with no load on the weighing pan.
5. KEYBOARD – BUTTONS FUNCTIONS
Button Overview
Press to switch the balance ON/OFF
Press to Zero the balance
Press to Tare the balance
Press to send measurement to a printer or a computer
To Next Page
Loading...
