RADWAG AS X2 Series

- 28 -
Determine mass using 20 parts Parts Counting mode exclusively
Determine mass using 50 parts Parts Counting mode exclusively
Determine mass using 100 parts Parts Counting mode exclusively
Thresholds Checkweighing mode exclusively
Min threshold Checkweighing mode exclusively
Max threshold Checkweighing mode exclusively
Target value Dosing mode exclusively
Set reference mass
Percent Weighing mode
exclusively
Determine reference mass (set as
100%)
Percent Weighing mode
exclusively
Start
Solids and Liquids Density modes
and Formulations mode
Results Statistics mode exclusively
Finish Statistics mode exclusively
Finish Peak Hold mode exclusively
Formulation Formulations mode exclusively
7.6.2. Labels
You can select label size and type of information to be displayed for a particular label.
In order to select a particular label, use a list of available labels. Upon label selection, specify type of
information to be displayed for the label. The selected label is displayed automatically on a specified
home screen spot.
Procedure:
Press and hold for a while the spot where
a given label is to be placed.