Upon unpacking the balance
remove any protective
elements and assembly the
(2) on the balance base,
mounted onto the balance
- assemlby draft shield (1),
only for balances with pan Φ
115 mm
- plug the power adapter
interface into the port of
interfaces housing, next
connect the power adapter
to mains. The balance will
CAUTION:
While cleaning it is advisable to follow below precautions. Additionally it is a
must to disconnect the device from mains and unplug all the peripherals
(printers, computer etc.) remembering at the same time to protect ports by
means of stoppers. Only thus prepared device can be cleaned. Upon
completion of the cleaning process the device may be connected to mains for
futher operation.
To Next Page
Loading...
Need help?
General