46
18.2. Reference mass setting
18.2.1. Inserting known mass of single piece
A
f
ter pressing key F + PCS or PAGE DOWN (keyboard PC) screen will appear
as drawing below. By means of PC keyboard insert mass of single sample in
basic unit of balance.
Fig. 29. Counting pieces – view of display
Pressing ENTER will cause moving to Counting pieces mode with automatic
setting of single detail mass (SMP – description on display) as current one.
Notice:
One should not insert sample mass bigger than max range of main balance
weighing and smaller than 0.1 of reading unit of this balance.
18.2.2. Determining (weighing) by declared quantity of sample
Fig. 30. Counting pieces- sample quantity selection
To Next Page
Loading...
