RADWAG WTC 200 - Operation Panel; 7 Installation; Unpacking and Installation

10
6.4. Operation Panel
Figure 4. Operation panel of WTC series scales
Keys:
Press to switch the weighing device on/off – hold the key for about 1
second.
Function key, press to change the working mode.
Press to send the weighing result to a printer or computer.
Press to zero the scale.
Press to tare the scale.
Upon pressing + keys combination, functions
of given keys change. Detailed information concerning use
of + keys combination is to be found further down
this manual.
7. INSTALLATION
7.1. Unpacking and Installation
 Unpack the device and place it on a flat and even surface. Keep it far
away from any sources of heat.