Install the weighing pan and the draft shield, follow figure 5.
Figure 5. Scale assembly
7.2. Levelling
To level the weighing instrument turn its feet. Keep turning the feet until the air
bubble takes central position:
7.3. Connecting the Scale to the Mains
The weighing device can be connected to the mains only with a power supply
that comes standard with the particular model. Nominal voltage of the power
supply (specified on the power supply data plate) has to be compatible with
the mains nominal voltage.
Procedure:
Connect the power supply to the mains. Plug it to the power supply socket
(back side of the scale housing).
Press key. The key is also used to switch the scale on/off.
To Next Page
Loading...
