Radwin Transportation FiberinMotion - Page 21

FinMDeploymentGuide Release4.5.10 2‐8
TBSMounting SiteInstallation
Verticalpole‐medium
1. Diameter2to3:BeforeraisingtheTBSonthepole,positionthepoleclampasshownin
thefollowingtwofigures.Donotcompletelytightenthebolts:
2. PlacethisassemblyonthepolewhereyouwanttomounttheTBS.Onceitisinplace,
rotatethepoleclampasshown,thentightenbothbolts.
VerticalPole‐thick
1. Diameterlargerthan3:Usewormdriveclamps(notsupplied),threadedthroughtheholes
asshowninFigure 2‐13,orU‐bolts(notsupplied),fastenedusingtheholesasshownin
Figure 2‐14:
Figure2‐9:Mediumpole:Fastenclampto
baseplate
Figure2‐10:Mediumpole:Donotcom‐
pletelytightenbolts
Figure2‐11:Mediumpole:R otateclamp Figure2‐12:Mediumpole:tightenbolts