Radwin Transportation FiberinMotion - Page 42

FinMDeploymentGuide Release4.5.10 2‐29
LightningProtectionUnit(LPU) SiteInstallation
TheLPUhastwocableglandsonthebottomforCAT‐5e/6cables,inadditiontoagrounding
lug.Thereisanextraholeforasecondscrewwheninstalledonawall.OnthesideoftheLPU
isaslotforthemetaltiewheninstalledonapole,asshowninFigure 2‐55andFigure 2‐56:
 ToinstallanLPUonapole:
1. Choosealocationascloseaspossibletotheradiounit.
2. InsertthemetaltiethroughtheslotsasshowninFigure 2‐56.MakesuretheLPUis
orientedinthecorrectdirection,asshowninFigure 2‐57.
Figure2‐57:LPUattachedtopolewithmetaltie
3. Tightenthemetaltie.
4. Connectthegroundinglugtoagroundingsource.
5. Removethecableglands.
6. ThreadtheCAT‐5e/6cablesthroughthecableglands,andconnectthecablestothe
LPUasshowninFigure 2‐58.
Figure2‐55:LPU:BottomView Figure2‐56:LPU:SideView