Q: What should I do if the water valve inlet keeps leaking?
Tighten the connection between the timer and the tap.
A filter and seal for the water inlet is essential. Check that the seal at the water
inlet is fitted before connecting the tap.
Mount the timer vertically on the floor to avoid damage to the inside of the unit.
(We do not recommend using it at an angle, even horizontally, as this may
damage the internal valves and cause leaks.)
Q: What should I do if the valve cannot be opened/closed?
The batteries are low and cannot drive the valve body. Need to replace with
brand new 2* AAA alkaline batteries.
You can restart the valve by following the steps below and the appliance will be
ready for normal use.
To Next Page
Loading...
Need help?
General
