Q: What should I do if I have set a schedule but it is not executed on
time?
Rotate to the set clock page and adjust the time to the correct time and date
(note the 12/24 time system), then set the START TIME to the desired time.
After setting the schedule, turn the knob to the ON page and wait for the
irrigation schedule to be executed.
The default schedule does not run when HOW LONG is set to 0, so check the
HOW LONG parameter setting when setting the irrigation schedule.
Check that the HOW OFTEN page is set to the time the schedule needs to be on.
Check the battery level. If the device is low, it will go into low battery protection
and the schedule will not run.
Q: What should I do if the water pressure is too low?
Install a booster pump or other method of increasing the pressure, the product
itself does not have a pressurisation function.
Q: Little or no water coming out?
Clean the impurities from the timer filter.
Make sure the appliance valve is in the open position.
Open the hose tap.
Q: What is wrong with batteries that always die easily?
Replace the batteries with new alkaline batteries, do not mix old and new
batteries, and do not mix carbon alkaline batteries.
The aging and rusting of the poles in the battery compartment will cause the
battery to run out of power too quickly. Take care to remove the battery when
the device is not used for a long time to avoid battery leakage.
To Next Page
Loading...
