Raise3D E2_Quick Start Guide
www.raise3d.com
- 5 -
The firmware is based on RepRapFirmware (https://github.com/dc42/RepRapFirmware)
The electronics inspired by Duet3D.
DUET 2 WIFI and DUET 2 ETHERNET LICENSE
The Duet WIFI/ DUET 2 WIFI and DUET ETHERNET are licensed under the terms of the CERL OHL 1.2 (see below or
http://www.ohwr.org/attachments/2388/cern_ohl_v_1_2.txt for full text) will the following additional conditions:
a. Attribution:
Any reproductions or modifications of the hardware must contain the following attribution on the silkscreen and
packaging:
"Based on the DuetWifi by Think3dPrint3d and Esher3d, see www.duet3d.com for the original DuetWifi
information. This reproduction/modification is not endorsed or supported in any way by Think3dPrint3d or
Escher3d".
b. Logos:
No reproduction or modification of the Duet 2 Wifi or Ethernet hardware may contain the Think3dPrint3d,
Escher3d or Duet3d logos.
Should you need any further information, please do not hesitate to email us at inquiry@raise3d.com.
To Next Page
Loading...
