LIGHT CHECK
Pressing the Light Check tab will open the Light Check
Ready page. A box will appear with the text “Activate
Light Check”, which will allow you to check your trailer’s
brake lights.
Once selected, the screen will change to “Light Check
in Progress”. The box will turn red and the text will read
“Cancel Light Check”, which will then turn the trailer’s
brake lights back off.
Checking “Auto Trailer Light Check” in the “Trailer
Brake/Trailer” Uconnect Settings will automatically turn
on your trailer’s lights once the trailer is attached to the
vehicle. For more information
page 165.
NOTE:
After two minutes, if “Cancel Light Check” is not
selected, the screen will automatically revert back to
the Activate Light Check screen.
SETUP
After selecting your trailer of choice, selecting the Setup
tab will redirect to the Uconnect Settings “Trailer Brake/
Trailer” feature,
page 165.
NOTE:
Make sure that “Use this Trailer” is selected in order to
make any settings changes to that selected trailer.
Trailer Tow Pages Light Check Tab
Trailer Tow Pages Setup Tab
222 MULTIMEDIA
To Next Page
Loading...
