Custom Tile Configuration — If Equipped
To customize the instrument cluster further, you are
able to select up to five tiles to display information
based on your needs.
•
Press the MENU button for the Home Screen display
•
Navigate Left or Right to highlight desired
tile
•
Press OK to select the tile and navigate to the
selected submenu and press OK again to add your
selection to your tile view
•
The main menu options of the home screen are
Driver Info, Vehicle Info, Navigation — If Equipped,
Audio, and Off Road
You can customize your Instrument Cluster Display with
up to five tiles that may consist of the following:
NOTE:
These options may vary based on your vehicle trim
level.
•
Navigation
○ Route Set / Route Not Set
○ TripA/TripB
•
Vehicle Info
○ Coolant Temp
○ Trans Temp
○ Oil Temp
○ Oil Pressure
○ Battery Voltage
○ Oil Life
○ Tire Pressure
○ Fuel Economy
○ Air Suspension
•
Driver Info
○ Driver Assist
•
Audio
○ Audio Info
•
Off Road
○ Selec-Terrain / Air Suspension Status
○ Steering Angle
○ Pitch
○ Roll
•
Trailer Tow
○ Trailer Trip
○ Trailer Brake
○ Trailer Tire Pressure Monitor
OIL LIFE RESET
Use this QR code to access your digital
experience.
Your vehicle is equipped with an engine
oil change indicator system. The “Oil
Change Required” message will display
in the instrument cluster display after a
single chime has sounded, to indicate the next sched-
uled oil change interval. The engine oil change indicator
system is duty cycle based, which means the engine oil
change interval may fluctuate, dependent upon your
personal driving style.
NOTE:
Use the steering wheel instrument cluster display con-
trols for the following procedure.
Oil Life Reset Procedure
1. Without pushing the brake pedal, push the ENGINE
START/STOP button and place the ignition to the
ON/RUN position (do not start the engine).
2.
Push and release the down
arrow button to scroll
downward through the main menu to “Vehicle Info.”
3. Push and release the right
arrow button to
access the ”Vehicle Info” screen, then scroll up or
down to select “Oil Life.”
4. Push and hold the right
arrow button to select
“Reset”.
5. Push and release the down
arrow button to
select “Yes,” then push and release the right
arrow button to reset the Oil Life to 100%.
6. Push and release the up
arrow button to exit the
instrument cluster display screen.
Custom Tile Screen Example
Scan me
80 GETTING TO KNOW YOUR INSTRUMENT PANEL
To Next Page
Loading...
