HIGHLINE INSTRUMENT CLUSTER
DESCRIPTIONS
1. Tachometer
○
Indicates the engine speed in revolutions per
minute (RPM x 1000).
2. Instrument Cluster Display
○
When the appropriate conditions exist, this dis-
play shows the instrument cluster display mes-
sages
page 78.
○
The display always shows one of the main menu
item after the ignition is placed on.
3. Speedometer
○
Indicates vehicle speed.
4. Temperature Gauge
○
The gauge pointer shows engine coolant tem-
perature. The pointer positioned within the nor-
mal range indicates that the engine cooling sys-
tem is operating satisfactorily.
○
The gauge pointer will likely indicate a higher
temperature when driving in hot weather, up
mountain grades, or when towing a trailer. It
should not be allowed to exceed the upper lim-
its of the normal operating range.
WARNING!
A hot engine cooling system is dangerous. You or oth-
ers could be badly burned by steam or boiling cool-
ant. It is recommended to call an authorized dealer
for service if your vehicle overheats. If you decide to
look under the hood yourself, follow the warnings
under the Cooling System Pressure Cap paragraph
page 297.
CAUTION!
Driving with a hot engine cooling system could dam-
age your vehicle. If the temperature gauge reads “H,”
pull over and stop the vehicle. Idle the vehicle with
the air conditioner turned off until the pointer drops
back into the normal range. If the pointer remains on
the “H,” turn the engine off immediately and call an
authorized dealer for service.
5. Fuel Gauge
○
The pointer shows the level of fuel in the fuel
tank when the ignition is in the ON/RUN
position.
○
The fuel pump symbol points to the
side of the vehicle where the fuel
door is located.
NOTE:
The Instrument Cluster Warning Indicators will illu-
minate briefly for a bulb check when the ignition is
first cycled.
70 GETTING TO KNOW YOUR INSTRUMENT PANEL
To Next Page
Loading...
