Secondary Method Of Resetting Engine Oil Life
1. Without pressing the brake pedal, push the ENGINE
START/STOP button and place the ignition to the
ON/RUN position (do not start the engine).
2. Fully press the accelerator pedal, slowly, three times
within ten seconds.
3. Without pushing the brake pedal, push the ENGINE
START/STOP button once to return the ignition to the
OFF position.
NOTE:
If the indicator message illuminates when you start the
vehicle, the oil change indicator system did not reset. If
necessary, repeat this procedure.
DISPLAY MENU ITEMS
Push and release the up or down arrow button
until the desired selectable menu icon is highlighted in
the instrument cluster display.
The instrument cluster display menu items may consist
of the following:
Speedometer Vehicle Info Off Road —
If Equipped
Driver Assist —
If Equipped
Fuel Economy Trip A/Trip B
Screen Set Up Vehicle Settings
— If Equipped
Commercial
Settings —
If Equipped
Trailer Tow Audio Messages
Speedometer
Push and release the up or down arrow button
until the speedometer menu item is highlighted in the
instrument cluster display. Push and release the right
arrow button to cycle the display between mph
and km/h.
Driver Assist — If Equipped
The Driver Assist menu displays the status of the ACC
system.
Push and release the up
or down arrow button
until the Driver Assist menu is displayed in the instru-
ment cluster display.
Adaptive Cruise Control (ACC) Feature
The instrument cluster display displays the current ACC
system settings. The information displayed depends on
ACC system status.
Push the ACC on/off button (located on the steering
wheel) until one of the following displays in the instru-
ment cluster display:
Adaptive Cruise Control Off
When ACC is deactivated, the display will read “Adaptive
Cruise Control Off.”
Adaptive Cruise Control Ready
When ACC is activated but the vehicle speed setting
has not been selected, the display will read “Adaptive
Cruise Control Ready.”
Push the SET + or the SET- button (located on the steer-
ing wheel) and the following will display in the instru-
ment cluster display:
ACC SET
When ACC is set, the set speed will display in the instru-
ment cluster.
The ACC screen may display once again if any ACC activ-
ity occurs, which may include any of the following:
•
Distance Setting Change
•
System Cancel
•
Driver Override
•
System Off
•
ACC Proximity Warning
•
ACC Unavailable Warning
NOTE:
The instrument cluster display will return to the last
display selected after five seconds of no ACC display
activity
page 126.
LaneSense — If Equipped
The instrument cluster display displays the current
LaneSense system settings. The information displayed
depends on LaneSense system status and the condi-
tions that need to be met
page 137.
Vehicle Info
Push and release the up or down arrow button
until the Vehicle Info menu item is highlighted in the
instrument cluster display. Push and release the right
arrow button to enter the submenus items of
Vehicle Info. Follow the directional prompts to access or
reset any of the following Vehicle Info submenu items:
BASE AND MIDLINE CLUSTER
•
Tire Pressure Monitor System
•
Coolant Temperature — If Equipped
•
Trans Temperature — If Equipped
•
Oil Temperature
•
Oil Pressure
•
Exhaust Brake — If Equipped
•
Boost Pressure — If Equipped
•
Diesel Particulate Filter
GETTING TO KNOW YOUR INSTRUMENT PANEL 81
3
To Next Page
Loading...
