EasyManua.ls Logo

RAM CHASSIS CAB 2024 - Outside Automatic Dimming Mirror - if Equipped; Power Mirrors - if Equipped; Power Folding Mirrors - if Equipped

RAM CHASSIS CAB 2024
360 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Outside Mirrors With Turn Signal And
Approach Lighting If Equipped
Driver and passenger outside mirrors with turn signal
and approach lighting contain LEDs, which are located
in the lower outer corner of each mirror.
The outer LEDs are turn signal indicators, which flash
with the corresponding turn signal lights in the front
and rear of the vehicle. Turning on the Hazard Warning
flashers will also activate these LEDs.
The approach lighting, which turns on in both mirrors
when you use the key fob or open any door is located
on the underside of the mirror.
The illuminated entry lighting fades to off after about
30 seconds or it will fade to off immediately once the
ignition is placed in the ON/RUN position.
NOTE:
The approach lighting will not function when the gear
selector is moved out of the PARK position.
OUTSIDE AUTOMATIC DIMMING
MIRROR IF EQUIPPED
The exterior mirrors will automatically adjust for glare
from vehicles behind you. This feature is controlled by
the inside automatic dimming mirror. The mirrors will
automatically adjust for headlight glare when the inside
mirror adjusts.
POWER MIRRORS IF EQUIPPED
The controls for the power mirrors are located on the
driver's door trim panel.
The power mirror controls consist of mirror select but-
tons and a four-way mirror control switch.
To adjust a mirror, push either the L (left) or R (right)
button to select the mirror that you want to adjust.
Using the mirror control switch, push on any of the four
arrows for the direction that you want the mirror to
move.
POWER FOLDING MIRRORS
IF EQUIPPED
The power folding mirrors can be folded rearward and
unfolded into the normal driving position.
The switch for the power folding mirrors is located
between the power mirror switches L (left) and R (right).
Push the switch once and the mirrors will fold in, push
the switch a second time and the mirrors will return to
the normal driving position.
If the mirror is manually folded after a powered cycle, a
potential extra button push is required to get the mir-
rors back to the normal driving position. If the mirror
does not fold automatically, check for ice or dirt buildup
at the pivot area, which can cause excessive drag.
Power Mirror Controls
1 Left Mirror Selection
2 Mirror Direction Control
3 Right Mirror Selection
Power Mirror Movement
38 GETTING TO KNOW YOUR VEHICLE

Table of Contents

Related product manuals