HEADLIGHTS ON WITH WIPERS
If your vehicle is equipped with Automatic Headlights, it
also has this customer-programmable feature. When
your headlights are in the automatic mode and the
engine is running, they will automatically turn on when
the wiper system is on. This feature is programmable
through the Uconnect system
page 165.
If your vehicle is equipped with the Rain Sensing Wiper
system
page 49, and it is activated, the headlights
will automatically turn on after the wipers complete five
wipe cycles within approximately one minute. They will
turn off approximately four minutes after the wipers
completely stop.
NOTE:
When your headlights come on during the daytime, the
instrument panel lights will automatically dim to the
lower nighttime intensity.
HEADLIGHT DELAY
To assist when exiting the vehicle, the headlight delay
feature will leave the headlights on for up to 90 sec-
onds. This delay is initiated when the ignition is placed
in the OFF position while the headlight switch is on, and
then the headlight switch is cycled off. Headlight delay
can be canceled by either turning the headlight switch
on then off, or by placing the ignition in the ON position.
NOTE:
•
This feature can be programmed through the
Uconnect system
page 165.
•
The headlight delay feature is automatically acti-
vated if the headlight switch is left in the AUTO posi-
tion when the ignition is placed in the OFF position.
LIGHTS-ON REMINDER
If the headlights, parking lights, or cargo lights are left
on after the ignition is placed in the OFF position, a
chime will sound and a message will appear in the
instrument cluster display when the driver’s door is
opened.
FRONT FOG LIGHTS — IF EQUIPPED
To activate the front fog lights, turn on the parking lights
or low beam headlights and push the fog light switch
located within the headlight switch. Pushing the fog
light switch a second time will turn the front fog lights
off.
TURN SIGNALS
Move the multifunction lever up or down to activate the
turn signals. The arrows on each side of the instrument
cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is
a very fast flash rate, check for a defective outside light
bulb.
LANE CHANGE ASSIST —
IF EQUIPPED
Lightly push the multifunction lever up or down, without
moving beyond the detent, and the turn signal will flash
three times then automatically turn off.
NOTE:
For information on Turn Signal Activated Blind Spot
Assist, see
page 139
Fog Light Switch
Fog Light Switch (Vehicles Sold In Canada Only)
46 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
