R&S ZNA50 - Page 1007

Command reference
R&S
®
ZNA
1007User Manual 1178.6462.02 ─ 20
The marker must be created before using CALCulate<Chn>:MARKer<Mk>[:STATe]
ON.
Setting this value is only possible in ARBitrary mode (see CALCulate<Chn>:
MARKer<Mk>:TYPE. For NORMal and FIXed mode markers it is read-only.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number.
Parameters:
<ResponseValue> Setting (ARBitrary mode only): sets the vertical position of the
marker in Y units of the current trace format.
Query: returns the marker position formatted according to the
current marker format (see CALCulate<Chn>:MARKer<Mk>:
FORMat), i.e. as displayed in the marker info field (1 return value
per row in the response column). Indetermined result values are
returned as a sequence of dashes (------). This may occur in
ARBitrary mode, if the transformation between trace format and
marker format requires a concrete stimulus value.
Default unit: NN
Example: Suppose that the active recall set contains an active trace no. 1.
CALC:MARK ON
Create marker no. 1 and display it in the center of the sweep
range.
CALC:MARK:Y?
Query the measurement value at the marker position.
CALC:MARK:STAT:AREA LEFT, TOP
For a subsequent check at the GUI or a hardcopy, move the info
field to the top left position.
Manual operation: See "Mkr <i> Arb. Response / Ref Mkr Arb. Response"
on page 451
7.3.1.15 CALCulate:MATH...
The CALCulate:MATH... commands permit processing of measured data in numeri-
cal expression format. The operators are +, -, *, / and use of constants and data arrays
are permitted.
CALCulate<Chn>:MATH[:EXPRession]:SDEFine............................................................ 1008
CALCulate<Chn>:MATH:FORMatted[:EXPRession]:SDEFine...........................................1008
CALCulate<Chn>:MATH:FUNCtion................................................................................1009
CALCulate<Chn>:MATH:FORMatted:FUNCtion.............................................................. 1009
CALCulate<Chn>:MATH:MEMorize................................................................................1010
CALCulate<Chn>:MATH:STATe.....................................................................................1010
CALCulate<Chn>:MATH:FORMatted:STATe................................................................... 1010
CALCulate<Chn>:MATH:WUNit[:STATe]......................................................................... 1011
SCPI command reference