GUI reference
R&S
®
ZNA
835User Manual 1178.6462.02 ─ 20
5.19.7 Port Setup tab
Collects functions for the (re) definition of internal and external physical ports and their
signal paths.
5.19.7.1 Controls on the Port Setup tab
Define Ports...
Opens a dialog that allows you to redefine the physical VNA ports. See Chap-
ter 5.19.7.2, "Define Physical Ports dialog", on page 835.
Input / Output
Opens the Input/Output tab of the Port Settings dialog.
Combiner
Tells the analyzer if and how signals from two ports are combined. For descriptions and
visualizations of the supported combiner configurations, see "Combiner Configuration"
on page 338.
5.19.7.2 Define Physical Ports dialog
Allows you to redefine the physical VNA ports (see Chapter 4.3.1.2, "Redefined S-
parameters", on page 124).
Access: System – [Setup] > "Port Setup" > "Define Ports..."
●
Redefined physical ports are global, persistent settings, i.e. they are valid for all
recall sets. A [Preset] does not reset the physical port configuration.
●
Redefining physical ports causes a factory reset.
Setup softtool
To Next Page
Loading...
