R&S ZNA50 - Offset Embed Softtool; Offset Embed Dock Widget

GUI reference
R&S
®
ZNA
651User Manual 1178.6462.02 ─ 20
Timer Settings
This button group allows you to define how the firmware calculates the "hardware set-
tling wait times" in the current channel.
"Auto" (default)
Let the firmware choose the suitable algorithm, based on the chan-
nel's current measurement task
"MonoFre-
quent"/"Freq-
Convert-
ing"/"Slow"
Manually (and statically) select one of the "hardware settling wait
time" calculation algorithms
Remote command:
[SENSe<Ch>:]SWEep:TIME:MODE
5.14 Offset Embed softtool
The "Offset Embed" softtool allows you to define a length offset and loss for each test
port. The offset compensates for the known length and loss of (non-dispersive and per-
fectly matched) transmission lines between the calibrated reference plane and the
DUT. It also contains advanced functions for deembedding/embedding the DUT from/
into more general physical/virtual (matching) networks placed between the calibrated
reference plane and the DUT.
Access: Channel – [Offset Embed]
Background information
Refer to Chapter 4.6, "Offset parameters and de-/embedding", on page 201
5.14.1 Offset Embed dock widget
On activating a tab in the "Offset Embed" softtool, a dock widget is displayed beneath
the trace area, whose content pane is synchronized with the selected softtool tab.
Access: Channel – [Offset Embed]
5.14.1.1 Overview panel
Shows an overview of the overall calculation flow and provides quick access to the
"Offset Embed" functions.
Access: Channel – [Offset Embed] > "Overview"
Offset Embed softtool