R&S ZNA50 - Calculate<Chn>:Eye:mask AUTO

Command reference
R&S
®
ZNA
911User Manual 1178.6462.02 ─ 20
CALCulate<Chn>:EYE:JITTer:TYPE:RANDom <Boolean>
Enables/disables random jitter insertion in the generator simulation of the related eye
diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
The standard deviation can be set using CALCulate<Chn>:EYE:JITTer:RANDom:
STDDeviation.
Note that jitter will not be applied unless the jitter functionality is activated using
CALCulate<Chn>:EYE:JITTer:STATe.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> *RST: OFF
Options: R&S ZNA-K20
Manual operation: See "Random" on page 747
CALCulate<Chn>:EYE:JITTer:TYPE:USER <Boolean>
Enables/disables user-defined jitter insertion in the generator simulation of the related
eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Prior to enabling user-defined jitter, the jitter values must have been loaded from file
using MMEMory:LOAD:EYE:JITTer.
Note that jitter will not be applied unless the jitter functionality is activated using
CALCulate<Chn>:EYE:JITTer:STATe.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> *RST: OFF
Options: R&S ZNA-K20
Manual operation: See "User Specific" on page 748
CALCulate<Chn>:EYE:MASK AUTO
Automatically creates an eye mask, based on the current eye measurement settings.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Usage: Setting only
SCPI command reference