GUI reference
R&S
®
ZNA
747User Manual 1178.6462.02 ─ 20
Remote command:
CALCulate<Chn>:EYE:EMPHasis:CURSor:PRE
CALCulate<Chn>:EYE:EMPHasis:CURSor:POST<1|2>
Jitter
The "Define Eye Jitter" dialog allows you to add jitter to the digital signal simulated for
the eye diagram measurement.
Access: "Jitter" button in the Advanced Settings dialog
This dialog is available with
Extended time domain analysis option R&S ZNA-K20 only.
Four types of jitter can be configured and selectively enabled: random, periodic, Dirac
and user defined. If enabled, the jitter is added at the start of each symbol period, and
its magnitude depends on the parameters specified in the dialog.
Active
This button must be first checked to activate any of the jitter sources. At this point,
each of the individual jitter sources can be activated.
Remote command:
CALCulate<Chn>:EYE:JITTer:STATe
Random
Random jitter is determined from a normal (Gaussian) random distribution whose
mean is zero, and whose "Std. Deviation" in seconds is specified by the user.
Applic softtool
To Next Page
Loading...
