R&S ZNA50 - Page 909

Command reference
R&S
®
ZNA
909User Manual 1178.6462.02 ─ 20
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<PeriodicPhase> *RST: 0 deg
Default unit: deg
Options: R&S ZNA-K20
Manual operation: See "Periodic" on page 748
CALCulate<Chn>:EYE:JITTer:RANDom:STDDeviation <StdDeviation>
Defines the standard deviation of the random jitter in the generator simulation of the
related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Random jitter insertion can be enabled using CALCulate<Chn>:EYE:JITTer:
TYPE:RANDom.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<StdDeviation> Default unit: s
Options: R&S ZNA-K20
Manual operation: See "Random" on page 747
CALCulate<Chn>:EYE:JITTer:STATe <Boolean>
Activates the jitter functionality in the generator simulation of the related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
The individual jitter sources can be selectively enabled using
●
CALCulate<Chn>:EYE:JITTer:TYPE:DIRac
●
CALCulate<Chn>:EYE:JITTer:TYPE:PERiodic
●
CALCulate<Chn>:EYE:JITTer:TYPE:RANDom
●
CALCulate<Chn>:EYE:JITTer:TYPE:USER
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> *RST: OFF
Options: R&S ZNA-K20
SCPI command reference