R&S ZNA50 - Control:vse:local

Command reference
R&S
®
ZNA
1134User Manual 1178.6462.02 ─ 20
Setting parameters:
<FilePathOnVna> A file path on the R&S ZNA, either absolute or relative to the
current directory (see MMEMory:CDIRectory)
Usage: Setting only
Manual operation: See "Load VSE Configuration" on page 646
CONTrol:VSE:CONFig:SAVE <FilePathOnVna>
If a connection to a R&S VSE instance is established, you can download its current
configuration and save it to a file on the R&S ZNA.
Setting parameters:
<FilePathOnVna> A file path on the R&S ZNA, either absolute or relative to the
current directory (see MMEMory:CDIRectory)
Usage: Setting only
Manual operation: See "Save VSE Configuration" on page 646
CONTrol:VSE:CONNect
If CONTrol:VSE:LOCal on page 1134 is set to 1, the setting tries to connect to a local
R&S VSE. Otherwise it tries to connect to a remote R&S VSE, whose VISA address
was previously specified using CONTrol:VSE:ADDRess.
The query returns the connection state: 1 = connected to a R&S VSE, 0 = not connec-
ted .
Manual operation:
See "Start/Connect VSE / Disconnect VSE" on page 645
CONTrol:VSE:DISConnect
Disconnects an active R&S VSE connection (see CONTrol:VSE:CONNect)
Usage:
Event
Manual operation: See "Start/Connect VSE / Disconnect VSE" on page 645
CONTrol:VSE:LOCal <Boolean>
Tells the R&S ZNA whether you want to connect to a local or remote R&S VSE
instance.
Use CONTrol:VSE:CONNect on page 1134 to establish the connection.
Parameters:
<Boolean> 1
Local R&S VSE
0
Remote R&S VSE
SCPI command reference