R&S ZNA50 - Page 1326

Command reference
R&S
®
ZNA
1326User Manual 1178.6462.02 ─ 20
Parameters:
<Value> Start/stop power in dB.
Example: See [SENSe<Ch>:]FREQuency:COMPression:POINt
on page 1324.
Manual operation: See "Start Power/Stop Power" on page 348
[SENSe<Ch>:]FREQuency:COMPression:SRCPort <Compression Point Source
Port>
[SENSe<Ch>:]FREQuency:COMPression:RECeiver <TestPort>
Defines the driving and receiving port for a gain compression measurement in channel
<Ch>.
Suffix:
<Ch>
.
Channel number
Parameters:
<TestPort> Port number
Example: See [SENSe<Ch>:]FREQuency:COMPression:POINt
on page 1324.
Manual operation: See "Driving Port/Receiving Port" on page 348
[SENSe<Ch>:]FREQuency:CENTer <CenterFreq>
Defines the center of the measurement and display range for a frequency sweep
(sweep range). The default center frequency is the center of the analyzer's maximum
frequency range: (f
MIN
+ f
MAX
)/2. The range depends on the instrument model; see
Table 7-17.
Suffix:
<Ch>
.
Channel number
Parameters:
<CenterFreq> Center frequency of the sweep
Increment: 0.1 kHz
Default unit: Hz
Example:
*RST; :SYST:FREQ? MIN; :SYST:FREQ? MAX
Query the frequency range of the analyzer.
FREQ:CENT 100MHz
Set center frequency to 100 MHz.
FREQ:SPAN 50000
Set frequency span to 50 kHz.
Manual operation: See "Start Frequency / Stop Frequency / Center Frequency /
Span Frequency" on page 474
SCPI command reference