R&S ZNA50 - Page 1569

Command reference
R&S
®
ZNA
1569User Manual 1178.6462.02 ─ 20
AR1 | AR2 | AR3 | AR4 | BR1 | BR2 | BR3 | BR4 |
CR1 | CR2 | CR3 | CR4 | DR1 | DR2 | DR3 | DR4 |
R1A | R1B | R1C | R1D | R2A | R2B | R2C | R2D |
R3A | R3B | R3C | R3D | R4A | R4B | R4C | R4D
Ratio of wave quantities b
1
/a
1
, b
1
/a
2
, ... , b
4
/a
4
, a
1
/b
1
,
a
1
/b
2
, ..., A
4
/B
4
(received waves to reference waves
or reference waves to received waves)
R1R2 | R1R3 | R1R4 | R2R1 | R2R3 | R2R4 | R3R1
| R3R2 | R3R4 | R4R1 | R4R2 | R4R3
Ratio of wave quantities a
1
/a
2
, a
1
/a
3
, ... , a
4
/a
3
(refer-
ence waves only)
CALCulate<Chn>:MARKer<Mk>:FUNCtion:BWIDth <Bandwidth>
Defines the bandfilter level, i.e. the minimum excursion for the bandpass and bandstop
peaks.
Tip: Use CALCulate<Chn>:MARKer<Mk>:BWIDth to set the bandwidth and query
the results of a bandfilter search. Note the sign convention for input values.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
<Mk> This numeric suffix is ignored and may be set to any value
because the bandfilter search functions always use markers M1
to M4.
Parameters:
<Bandwidth> Range: -100 dB to 100 dB
Increment: 0.03 dB
*RST: 3 dB
Default unit: dB
Example: See CALCulate<Chn>:MARKer<Mk>:BWIDth
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DELTa:STATe <Boolean>
Switches the delta mode for marker <Mk> on trace no. <Chn> on or off.
Note: This command is the ZVR-compatible equivalent of CALCulate<Chn>:
MARKer<Mk>:DELTa[:STATe].
Suffix:
<Chn>
.
Channel number used to identify the active trace.
<Mk> Marker number.
Parameters:
<Boolean> ON | OFF - enable or disable the delta mode.
*RST: OFF
CALCulate<Chn>:MARKer<Mk>:FUNCtion:TARGet <SearchValue>
Defines the target value for the target search of marker no. <Mk>, which can be activa-
ted using CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute TARGet.
Note: This command is the ZVR-compatible equivalent of CALCulate<Chn>:
MARKer<Mk>:TARGet.
R&S ZVR/ZVABT compatible commands