GUI reference
R&S
®
ZNA
637User Manual 1178.6462.02 ─ 20
5.13.2.1 Controls on the Pulse Mod tab
"Pulse Mod..." opens the Pulse Modulation dialog.
Pulse Generator
Enables or disables pulse generation.
Remote command:
[SENSe<Ch>:]PULSe:GENerator<Id>[:STATe]
Set all Traces to Matching Detector
Tells the firmware to select a suitable detector for all traces in the current channel. For
background information, see Chapter 4.3.5.3, "Detector settings", on page 133.
VSE Settings
The controls in the "VSE Settings" part of the "Pulse Mod" tab allow you to set up, con-
figure and run Chapter 4.7.6.1, "Live pulse analysis with R&S VSE", on page 251.
Configure VSE ← VSE Settings
Opens the VSE Connection Configuration dialog that allows you to establish a connec-
tion to a local or remote R&S VSE instance.
VSE Mode ← VSE Settings
Determines where the acquired measurement data are processed.
"ZNA Only"
(default)
The selected b-wave trace is calculated in the R&S ZNA; no data are
pushed to the configured R&S VSE instance.
"VSE Only"
The R&S ZNA does not calculated the selected trace. Instead, it pre-
pares I/Q data for the measured b-wave and pushes them to the
R&S VSE for further analysis.
Mode softtool
To Next Page
Loading...
