GUI reference
R&S
®
ZNA
760User Manual 1178.6462.02 ─ 20
Note: The R&S ZNA does not have a built-in audio device and loudspeaker. To hear
these sounds, connect a USB audio device to the instrument or operate it via remote
desktop.
Remote command:
CALCulate<Chn>:DTIMe:LIMit:FAIL:BEEP
Global Check, TTL1 Pass, TTL2 Pass
see Chapter 5.6.1, "Limit Test tab", on page 431
5.17.2.11 Time Gate tab
Replicates the "Time Gate" tab of the "Traces" softtool (see Chapter 5.5.6, "Time Gate
tab", on page 407).
Access: System – [Applic] > "TDR" > "Time Gate"
Since for the eye diagram, the time axis always equals two times the symbol time, the
display of the time gate range lines ("Show Range Lines") does not make sense, and is
therefore not available.
5.17.2.12 Y Axis tab
The "Y Axis" tab allows you to define the y axis scaling of the active diagram. The scal-
ing logic is the same as for all other diagram types, see Chapter 5.4, "Scale softtool",
on page 380.
Access: System – [Applic] > "TDR" > "Y Axis"
This tab is only visible if the Extended time domain analysis option R&S ZNA-K20 is
available.
Applic softtool
To Next Page
Loading...
