R&S ZNA50 - Page 815

GUI reference
R&S
®
ZNA
815User Manual 1178.6462.02 ─ 20
Note: Remote languages other than DEFAULT are intended for remote control of the
analyzer. A mixed approach, with part of the instrument configuration defined via the
GUI, is possible but can cause unexpected results in some instances.
Remote command:
SYSTem:LANGuage
Define *IDN + *OPT...
Defines a format for the ID string and the option string of the analyzer. The default
strings are automatically adjusted to the selected "Remote Language". The strings can
be queried via *IDN? and *OPT?, respectively.
●
If the DEFAULT language is activated, the factory ID string
Rohde&Schwarz,ZNA<Max. Freq>-<Ports>Port,<Order and Serial No>,<FW_Ver-
sion> (e.g. Rohde-Schwarz,ZNA26-4Port,1332450024100005,1.50.2.19) is set.
The option string is a comma-separated list of all installed software and hardware
options. The bit order for transferred binary data is swapped (FORMat:BORDer
SWAPped).
●
If the PNA language is activated, Keysight-compatible ID and option strings are
set. The bit order for transferred binary data is normal.
●
If one of the "HP xxxx" languages is activated, "HP xxxx"-compatible ID and option
strings are set. Binary data is transferred in a device-specific bit order, however,
the bit order can be changed using "HP xxxx"-specific commands.
The ID and option strings can be changed or reset to the R&S factory ID string.
Remote command:
SYSTem:IDENtify[:STRing]
SYSTem:IDENtify:FACTory
SYSTem:OPTions[:STRing]
SYSTem:OPTions:FACTory
FORMat:BORDer
Advanced ...
Opens a dialog that allows to set the following parameters:
●
"Wait for Data after Sweep" determines the execution behavior of
INITiate[:IMMediate] commands (see Chapter 7.3.8, "INITiate commands",
on page 1170).
If enabled, an automatic *WAI is added (see Chapter 7.2, "Common commands",
on page 882).
By default this is disabled.
Setup softtool