Ransomes Highway3 - Lighting Kit (Optional); Seat Right Hand Arm Rest & Pod

en-47
6 CONTROLS
7
8
X
Y
Z
A
9
6.10 LIGHTING KIT (Optional)___________________________________________
Lighting control Stalk
A Push away from operator to turn main beam on.
B Pull towards operator to flash headlights.
C Move stalk up to indicate right turn.
D Move stalk down to indicate left turn.
E Push stalk in to sound horn.
NOTE: Side lights will operate when ignition is in the run
position
When the lighting kit is fitted a brake light function is
available. If brake lights are used rear view mirrors must
be fitted.
6.11 SEAT RIGHT HAND ARM REST & POD ______________________________
The right hand arm rest of the seat has an extension
mounted to it which carries the control pod.
To obtain a comfortable operating position:
a Release hand wheel (A).
b Using both hands grip the arm rest and lift or lower
the arm rest. It will move in a circular motion (X)
either moving up and forward or down and
rearwards.
c When the desired position is obtained lock by
tightening the hand wheel (A).
The pod can be pivoted in the horizontal
plane (Y), independently of the arm rest by:
d loosening the three screws (4) holding the pod to the arm rest extension.
e Swivel pod to desired position.
f Tighten the three screws 4).
The whole arm rest extension can be pivoted in the horizontal plane (Z).
g Remove the arm rest cushion by removing the four screws (9).
h Loosen the three locknuts (7) fitted to studs (8).
j Swivel the arm rest extension to the desired position.
k Replace arm rest cushion and secure with screws (9)
B
A
C
D
E