5.2.Z.1 LANGUAGE MENU_______________________________________________
Select the language
and accept
5.2.Z.2 LANGUAGE OPTION _____________________________________________
On the page for the language options, Press the button to select, press the button
up and down to move the
. When the
is moved up and down the languages,
it does not change until button is pressed to store the language. When the title bar,
i.e. the 'Language Menu' will change to the new language.
The options will be in the correct language i.e. English, Deutsch, Francais, Danish,
Swedish and Dutch.
Press the button to return to previous menu.
5.2.Z.3 WARNING SLOPE ANGLE 16° _____________________________________
During work if the machine is driven on a slope of 16º the screen will display this
warning. This over rides all other information, and will continue until the machine has
been driven to an area of less than 16º
Press the button below the
to confirm the fault.
5.2.Z.4 WARNING SLOPE ANGLE 18° _____________________________________
If the slope angle reaches 18º the screen will display this warning which indicates that
the cutting unit arms are locked in the lower position. An audible warning will be
sounded, the warning will sound four times every 4 seconds and the red LED’s will flash
four times every 4 seconds. This will continue until the machine has been driven to an
area of less than 15º.
Press the button below the
to confirm the fault.
Language
English
Deutsch
Francais
Dansk
Svensk
Netherlands
0°
Slopes > = 16°
in either x or y
To Next Page
Loading...
