Raspberry Pi RP2040 User Manual


NOTE
The pico directory will be created in the folder where you run the pico_setup.sh script.
Once it has run, you will need to reboot your Raspberry Pi,
$ sudo reboot
for the UART reconfiguration to take effect. Once your Raspberry Pi has rebooted you can open Visual Studio Code in
the "Programming" menu and follow the instructions from
Section 7.2.
Getting started with Raspberry Pi Pico
Chapter 1. Quick Pico Setup 5

Raspberry Pi RP2040 Specifications

General

Processor	Dual-core Arm Cortex-M0+
Clock Speed	133 MHz
SRAM	264 KB
GPIO	30
USB	USB 1.1 Host/Device
PWM	16 channels
UART	2
SPI	2
I2C	2
Temperature Range	-20°C to +85°C
Operating Voltage	1.8V to 3.3V
Flash	External QSPI flash
I/O Interfaces	SPI, I2C, UART, PWM
ADC	4 × 12-bit ADC channels