6 | Electrical connection
32 / 56 80.06.562_IM_2-XS_ 2-S_en-INT
NOTICE
Damage to the drill holes for covering the electrical compartment
Failure to follow the proper order of first removing and tightening the
electrical compartment cover bolts may damage the holes due to the pre-
load in the cover.
The electrical compartment is behind the right cover on the rear of the unit.
a The unit is standing on its intended installation surface.
a The unit top covers are closed.
a A cross-headed screwdriver is ready for use.
a All power sources are switched off by way of an external circuit breaker.
1. Remove the marked cross-headed screws (1) and remove the cover by
pulling it upwards (2).
To Next Page
Loading...
