1 | Introduction
80.06.070_iCombi Pro-iCombi Classic_IM_V01_en-GB 7 / 92
n
In order to prevent accidents or damage, the manufacturer recommends
that technicians attend training and safety instructions.
1.3 Copyrights
Forwarding product-specific information to third parties is prohibited. We re-
serve the right to make technical developments and changes in the interest of
progress. All rights, including to translation and duplication, are reserved.
1.4 Conformity
Appliance conformity refers to the overall unit at the time of delivery. The oper-
ator is responsible for ensuring extended conformity following any expansions,
modification and connection of additional functions.
Observe the corresponding local and country-specific standards and regulations
regarding the installation and operation of commercial cooking appliances.
Conformity Europe
n
The electricity connection has been constructed and tested according to IEC
60335 in consideration of EN 60335 and VDE 0700.
n
The water connection has been constructed and tested according to IEC
61770 in consideration of EN 1717 and EN 13077.
n
The drain connection meets the requirements of the applicable provisions
pursuant to WRAS, SVGW and KIWA and has been tested and certified ac-
cordingly.
n
The unit is approved for use up to 4,000 m above sea level according to IEC
60335.
Conformity USA and Canada
n
The power connection is built and tested according to UL 197or CSA C22.2
No. 109.
1.5 Liability and warranty provisions
Liability
Installations and repairs not carried out by professionals authorised by the man-
ufacturer or not using original service components, and technical modifications
to the unit, which are not approved by the manufacturer, may void the manufac-
turer’s product liability.
Warranty
Damage occurring as a result of non-compliance with this installation manual is
excluded from the warranty.
The following are also excluded from the warranty:
n
Damage resulting from improper use, installation, maintenance or repair
n
Damage resulting from improper descaling
n
Use of the unit for purposes other than those for which it is intended
n
Modifications or technical alterations to the unit not authorised by the man-
ufacturer
n
Use of non manufacturer-original service components
To Next Page
Loading...
Need help?
General