EasyManuals Logo

Ravaglioli GP3.140RS User Manual

Ravaglioli GP3.140RS
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 15 of 60
1
2
3
1
2
2
3
4
5
6
1
9.3.3 Fitting of external data gauge (standard
for G3.140RS - GP3.140RS versions)
(optional for G3.140R - GP3.140R ver-
sions)
1. Unscrew the fastening screws of the equalizer's
support (Fig. 13 ref. 1), being very careful about
holding the same support.
2. Unscrew the 3 screws (Fig. 13 ref. 2) to the gauge
bracket (Fig. 13 ref. 3) and in the special inserts
placed on the rear side of the frame.
Lock the gauge arm (Fig. 13 ref. 4) by screwing
the 2 screws provided (Fig. 13 ref. 5). Lock these
screws with the nuts (Fig. 13 ref. 6) so that the
mandrel and the gauge arm are levelled out (see
Fig. 14).
Fig. 13
3. Also make sure the gauge tip (Fig. 14 ref. 1) is
positioned at the centre of the mandrel.
Fig. 14
4. Connect connector (Fig. 15 ref. 1) of the cable com-
ing from inside the machine to connector (Fig. 15
ref. 2) of the cable coming from the gauge arm. Fit
the section of the cable with the connectors inside
the arm (Fig. 15 ref. 3).
5. Fasten the cable with clamps.
6. Enable the external data gauge and carry out the
device's calibration.
Fig. 15
1297-M007-1_R
G3.140R - GP3.140R - G3.140RS - GP3.140RS
RAVAGLIOLI S.p.A.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ravaglioli GP3.140RS and is the answer not in the manual?

Ravaglioli GP3.140RS Specifications

General IconGeneral
BrandRavaglioli
ModelGP3.140RS
CategoryWheel Balancers
LanguageEnglish

Related product manuals