17
Tools Menu
Quick Access Bar
While viewing the Tools Menu, the Quick Access Bar is available at the top of
the screen and allows quick access the Favorites, System, GPS, Computer,
and Vehicle menus. Touch the Show All icon to view all menus within the
Tools Menu.
The following pages offer brief descriptions of the menu options which may be
found within the Tools Menu.
Favorites
System
Favorites Icon - Refer to the Favorites Menu section on page 20 to
set up the Favorites Menu.
Switch - Select the source for toggling history on or off. Install and
connect the optional external switch wire to a source of +12V power
to utilize the Hardware setting.
If Touch Screen is selected, touching or on the Guidance
Screen will toggle coverage history recording on or off.
Tilt - The Tilt icon is only displayed if an optional TM-1 Tilt Module is
connected to the console. Select the Tilt icon to setup and calibrate
the TM-1 Tilt Module. Touch the Information icon for detailed
information for this feature.
Note: The baud rate for Port B must be set to 19200 to allow Cruizer II
to communicate with the TM-1. See the Baud Rate Settings
section on page 27 for information on other configurations with
SmarTrax.
To Next Page
Loading...
