Raven Cruizer II - Baud Rate Settings

27
Baud Rate Settings
Baud rate settings allow the Cruizer II console to communicate with other
equipment such as steering, section control or DGPS systems or
components.
1. From the Home Screen, select:
Tools Menu GPS Output .
2. When connecting the products
listed below, ensure that the
appropriate port is selected and
all messages are set to zero.
3. Touch Baud Rates .
4. Use the following table to enter
the correct baud rate settings for
each port.
Product Port
SmartBoom/SmartRow A or B
TM-1 Tilt Sensor B
SmarTrax
(software version 4.1 or older)
B
Steering Node B
SCS Serial Rate Console A
Product Port A Port B
TM-1 Tilt Sensor --------- 19200
Datalogging with a Raven
SCS 4400/4600 Console
9600 ---------
Serial Rate Display with a Raven SCS
Serial Rate Controller
9600 ---------
SmarTrax
(software version 3.2 or older)
---------
38400
Recommended
SmarTrax
(software versions 4.0 or newer)
---------
115200
Recommended
Steering Node 115200 115200
SmartBoom/SmartRow
a
a.SmartBoom and SmartRow will forward the GGA and VTG
messages at 5 Hz when initializing the connection.
19200 19200
SmartYield 19200 ---------