36
Boom Control Hardware
This button allows you to change or set the boom control hardware.
There are six selections for the boom control hardware setup: Boom Sense
Wire, On-Screen Vehicle Arrow, AccuBoom Master Switch, Raven
Console, CAN System, and Boom Node/CAN Console.
1. Boom Sense Wire - will turn the coverage on or off automatically when
you turn the master switch on or off, when the master switch is wired to
the Envizio master switch wire.
2. On-Screen Vehicle Arrow - will turn the coverage map on or off when
you touch the vehicle arrow icon on the screen.
3. AccuBoom Master Switch - will show coverage based on the
AccuBoom master switch when the master switch is physically con-
nected to the AccuBoom master switch wire.
4. Raven Serial Console - selecting this will use your existing Raven
console to get your applied rates. MUST HAVE A MASTER
SWITCH CONNECTED AND BOOM SWITCHES OFF.
5. CAN System - selecting this will allow the system to use the
AccuBoom and/or Autoboom control. THIS MUST BE ENABLED
PRIOR TO USING ACCUBOOM OR AUTOBOOM.
6. Boom Node/CAN Console - select this option when using an Envizio
Plus with a SCS 4000 Series console on a CAN system to data log rate
from the CAN bus system. ALL BOOMS MUST BE ON IN ORDER
FOR ACCUBOOM TO WORK.
Helpful Hints:
• You must have the boom sense wire
connected to a +12 VDC signal source
(+12 VDC = map painting is ‘On’, 0 VDC =
map painting is ‘Off’).
• You can only select either the Boom Sense
Wire OR On-screen Vehicle Arrow option,
not both.
To Next Page
Loading...
