20
8. AUTOMATIC RATE +/-
This feature sets the increment at which flow is increased or decreased in AUTO operation. Select
RATE +/- for product by depressing
for PRODUCT 1 or for PRODUCT 2 until DATA
display flashes. To enter a value
, then increment value, and .
EXAMPLE: If rate is to changed by "1.0":
Enter a value of 1.0 for RATE +/-. When in AUTO, each time the INC/DEC switch is positioned to
INC the PROD CAL for that product will increase by "1.0". Likewise, when positioned to DEC the
PROD CAL will decrease by "1.0".
9. VOLUME/AREA RATE ALARM
Console alarm sounds if the application rate is 30% or more away from the target application rate
for more than 5 seconds.
NOTE: Go to DATA MENU to silence alarm.
10. LOW TANK FAULT
This feature will sound the alarm when the volume in the tank drops below an entered value. The
alarm will intermittently beep every 15 seconds and the DATA display will flash "LEVL". The alarm
will stop when a value equal to or greater than the LOW TANK ALARM is entered into VOL/TANK
or the booms are turned OFF. Entering "0" into LOW TANK ALARM disables it. To select LOW
TANK ALARM depress
for PRODUCT 1 or for PRODUCT 2 until the DATA display
flashes. To enter a value,
depress
, then LOW TANK ALARM value, and .
NOTE: Go to DATA MENU to silence alarm.
11. DATA MENU
The following are brief descriptions of features available under the DATA MENU key:
To Next Page
Loading...
Need help?
General
