31
NOTE: Some options within the DATA MENU LISTINGS may be unavailable if certain
features are on or active. The options affected are:
CONSOLE DATA PRINTOUT: Console Data Printout will not be available when DATA
LOGGER is ON or when GPS functions are ACTIVE.
GPS OPTIONS: GPS Options will not be available when DATA LOGGER is
ON.
DATA LOGGER: DATA LOGGER will not be available when GPS functions
are active.
12. DECIMAL SHIFT
The DECIMAL SHIFT feature is used to increase system accuracy at low application rates. Shifting
of the decimal point is done during the entry of METER CAL.
After entering METER CAL mode, depress the decimal shift
. Enter the meter calibration
constant number and depress . The sequence to unshift the decimals while in METER CAL
is to enter the meter calibration constant number and depress
. The following table illustrates
how shifting the decimal point can increase system accuracy.
DECIMAL PLACE LOCATIONS
US METRIC TURF
UNSHIFT SHIFT UNSHIFT SHIFT UNSHIFT SHIFT
PROD 1 DISPLAY 000.0 00.00 0000 000.0 00.00 00.00
PROD 2 DISPLAY 000.0 00.00 0000 000.0 00.00 00.00
PROD 1 CAL 000.0 00.00 0000 000.0 00.00 00.00
PROD 2 CAL 000.0 00.00 0000 000.0 00.00 00.00
PROD 1 VOLUME 0000 000.0 0000 000.0 000.0 000.0
PROD 2 VOLUME 0000 000.0 0000 000.0 000.0 000.0
VOLUME/TANK 1 0000 000.0 0000 000.0 000.0 000.0
VOLUME/TANK 2 0000 000.0 0000 000.0 000.0 000.0
DATA MENU FLo1 0000 000.0 0000 000.0 000.0 000.0
DATA MENU FLo2 0000 000.0 0000 000.0 000.0 000.0
DATA MENU LL1 0000 000.0 0000 000.0 000.0 000.0
DATA MENU LL2 0000 000.0 0000 000.0 000.0 000.0
PROD 1 RATE +/- 000.0 00.00 0000 000.0 00.00 00.00
PROD 2 RATE +/- 000.0 00.00 0000 000.0 00.00 00.00
PROD 1 LOW TANK 0000 000.0 0000 000.0 000.0 000.0
PROD 2 LOW TANK 0000 000.0 0000 000.0 000.0 000.0
When entering PROD 1 CAL and PROD 2 CAL, remember that 2 GPA [20 lit/ha] is entered as 2.0
[20.0] when unshifted and 2.00 [20.00] when shifted.
To Next Page
Loading...
Need help?
General
