Raven SCS 700 PGM Series User Manual

52
APPENDIX 8
TANK INJECTION MODULE INSTALLATION
1. PLUMBING THE INJECTION MODULE
1) Plumb Pressure Relief Valve (PRV), Flow Meter, Control Valve, Carrier Check Valve, Product Check
Valves, and In-line Mixer just ahead of the Boom On/Off Valves as shown in Figure 4.
2) Mount Injection Modules close to the Boom On/Off Valves to minimize amount of product in tubing.
3) Plumb output lines of Injection Modules to Product Check Valves (See Figure 23). Use 3/8 inch [10
mm] tubing on low volume modules and 1/2 inch [13 mm] tubing on high volume modules. Product
Check Valves and tubing not furnished.
FIGURE 23

Raven SCS 700 PGM Series Specifications

General

Brand	Raven
Model	SCS 700 PGM Series
Category	Music Mixer
Language	English