CHAPTER 3
38 ROS SmarTrax™ Calibration & Operation Manual
Resetting the SmarTrax system calibration will delete all system settings and adjustments that have been
performed. Before resetting the SmarTrax calibration, write down the current system settings for reference later.
Recalibrate the SmarTrax system after the system is reset.
ROUTINE OPERATION
ENGAGE SMARTRAX
FIGURE 33. SmarTrax Status Widget
NOTE: If the SmarTrax steering widget does not appear on the screen, refer to the Viper/Viper 4+ Installation
and Operation manual (P/N 016-0171-539) for further information on adding widgets.
Touch the SmarTrax status widget during field operations to engage and disengage the SmarTrax features as
desired during field operations.
NOTE: The operator liability waiver must be accepted before the SmarTrax system can be enabled for
operation.
The SmarTrax steering may also be engaged using the following methods:
• Tap the foot switch or rocker switch to engage SmarTrax features without touching the Viper 4 display.
• Press the SmarTrax on-screen status widget to engage the SmarTrax during field operation.
UPDATING THE NODE
Refer to the Viper 4 Installation & Operation Manual (P/N 016-0171-539) for instructions on updating the node
software.
To Next Page
Loading...
