RG25DH Operation • Service • Maintenance • Parts Manual
800.392.2686
29
Maintenance
BEFORE PERFORMING ANY MAINTENANCE,
PLEASE CONSULT THE “SAFETY” SECTION
OF THIS OPERATOR MANUAL FOR VITAL
INFORMATION RELATED TO OPERATING THIS
POWERFUL MACHINE!
Daily or Every 10 Hrs Maintenance Interval
Walk Around Inspection See list
Engine Oil Level Check & Replace if needed
Fuel Tank Check & Fill if needed
Grease & Oild Buildup Check
Engine Combustion Air Cleaner Check
Cutting Wheel Check Teeth
Every 50 Hrs Maintenance Interval
V-Belt Tension Check
Engine Air Cleaner Filter Change
Every 200 Hrs Maintenance Interval
Spark Plug Check Condition & Gap
Oil FIlter Change
Clutch Burnish
Every 500 Hrs or 1 Year Maintenance Interval
Bendix Starter Drive Service
Solenoid Shift Starter Clean
Hydrostatic Drive Check Levels & Belt Tension
Every 100 Hrs Maintenance Interval
Battery Check & Adjust
Cooling Shrouds Remove & Clean
Oil Cooler Fins Check & Clean
Clutch Re-Burnish
Every 300 Service Hrs
Tires Inspect
NOTICE
When consulting this manual regarding the longer
maintenance intervals, care must be taken to
not miss performing the shorter interval service
requirements when the shorter intervals happen
to coincide with the longer intervals, as, in such a
case, it should be noted that the shorter intervals
are not listed again along with the longer intervals.
The engine hour meter is a reliable tool for
measuring actual service hours of the machine.
When each maintenance item is performed, a
record of the current service hours and the date
should be made, and a note should also be made,
on a regularly viewed calendar, of when the next
interval that requires scheduled maintenance is
to occur, based on adding the amount of time for
that next interval to the time when performing
that maintenance, as suits the occasion. Then, as
you frequently compare the actual service hours
to the record, you will be properly informed to the
maintenance requirements as time passes.
The maintenance intervals listed in this
“Maintenance Intervals” section of this RG25HD
STUMP CUTTER Operator Manual includes engine
care topics. For the complete information, consult
the Engine Operation Manual.
Rayco has attempted to accurately predict
maintenance intervals for this machine. However,
due to varying environmental operating conditions
such as intense dust or moisture, or due to
heavier usage, your machine may require certain
maintenance at more frequent intervals than those
given in this manual. Thus, whenever variance is
found through the actual usage of this machine,
the published interval should be disregarded and a
more frequent interval applied.
Every 25 Hrs Maintenance Interval
Pre-Cleaner Element Service
To Next Page
Loading...
