42
TYPE 100/300 Operation and Installation Handbook
Cabling
The constant running interface must be used on all installations with
constant running hydraulic pumps. The main power supply is led to the
interface and then onto the course computer. The interface unit has
connections for the solenoid valves and the bypass valve, if one is
required. The pump should be wired (as shown) using the specified cable
size and designated circuit breaker.
Supply
Main breaker
Type CR
interface unit
To bypass
valve
Clutch drive
25A
Solenoid 'A' cable
Power pack motor supply
3L (12V) – 50A
4.5L (12V) – 70A
3L (24V) – 30A
4.5L (24V) – 40A
RLY1
D2
D1
+ – + – + –
+ –
+ –
+ –
BYPASS
VALVE
BATTERY
A B
SOLENOIDS
M1 M2
SUPPLY
CLUTCH
D778-1
To Next Page
Loading...
